FoundryGeneral® Foundry Adhesive 100 is a ready to use hot shell core and mold paste. When applied to the hot drag of a shell mold, FoundryGeneral® Foundry Adhesive 100 does not boil or dry out quickly, allowing the operator sufficient time to properly position the hot cope half of the mold. After 45 seconds of curing under pressure in the mold press, FoundryGeneral® Foundry Adhesive 100 develops an extra strong bond which eliminates metal run outs at the parting line and provides casting dimensional accuracy across the parting line.
TYPICAL PROPERTIES:
Appearance: Thick, yellow to orange paste
Viscosity: 10,000 cps
Flash Point: 428°F
Density: 8.55 lbs/gal
VOC: Not determine
pH: NA
RECOMMENDED APPLICATION:
FoundryGeneral® Foundry Adhesive 100 may have a slight separation when received. Mechanical agitation is required to thoroughly remix the foundry glue paste to a uniform consistency. Five minutes when first put into service and one minute at the start of each shift is recommended. Application of FoundryGeneral® Foundry Adhesive 100 can be done through a normal foundry type paste bulb or by liquid paste pump. Another application includes dispensing the foundry glue from the liquid applicator by a wiper blade traveling over a perforated template. FoundryGeneral® Foundry Adhesive 100 can also be accurately printed onto the shell by an appropriately contoured fixture with or without a vibrator. Please refer to the SDS for proper safety instructions.
BENEFITS:
Ready to use
Low smoke evolution
Extra strong bond
Reduces metal run out during pouring shells
MATERIAL COMPATIBILITY:
Avoid heat, sparks and open flames. Avoid strong oxidizing agents (i.e. bleach).
